Difference between revisions of "Gär Lämpli"
From Hackteria Wiki
(→Start layouting and drafting the correct connections with pencil) |
(→Overlay with a transparency sheet and draw the circuit traces and pads) |
||
Line 41: | Line 41: | ||
===='''Overlay with a transparency sheet and draw the circuit traces and pads'''==== | ===='''Overlay with a transparency sheet and draw the circuit traces and pads'''==== | ||
+ | |||
+ | Make sure you take some photo of your layout to refer to the part's position later. | ||
<gallery mode="packed-hover" heights=200px> | <gallery mode="packed-hover" heights=200px> | ||
Line 47: | Line 49: | ||
File:dusjagrs_garlampli.jpg | File:dusjagrs_garlampli.jpg | ||
</gallery> | </gallery> | ||
+ | |||
+ | ===='''Scan (or photo), scale it back down, pring and etch the boards'''==== | ||
+ | |||
+ | Coming soon... | ||
== Adding Sensors == | == Adding Sensors == |
Revision as of 14:34, 16 March 2017
Hmmm...
based on this new attiny bootloader and a minimal board to check / follow a fermentation curve time/temp profile and show by different colors.
Working on it for the upcoming Koji and Miso workshop at Dimension Plus Lab in Taipei.
Contents
- 1 What is it?
- 1.1 Creative PCB design tool
- 1.1.1 Prepare 400% scaled, printed, laminated and cut-out smd parts.
- 1.1.2 Discuss the difference between the "schematic" representation and "physical" implementation
- 1.1.3 Start layouting and drafting the correct connections with pencil
- 1.1.4 Overlay with a transparency sheet and draw the circuit traces and pads
- 1.1.5 Scan (or photo), scale it back down, pring and etch the boards
- 1.1 Creative PCB design tool
- 2 Adding Sensors
- 3 Souvenir Badge for Biohacking festivals?
- 4 Etymology of gären
What is it?
Documentation on NEO github-wiki
Creative PCB design tool
Prepare 400% scaled, printed, laminated and cut-out smd parts.
Download the files from the github.
Discuss the difference between the "schematic" representation and "physical" implementation
Start layouting and drafting the correct connections with pencil
we should add some sticky tape to fix them...
Overlay with a transparency sheet and draw the circuit traces and pads
Make sure you take some photo of your layout to refer to the part's position later.
Scan (or photo), scale it back down, pring and etch the boards
Coming soon...
Adding Sensors
- DS18B20 is a water-proofed sensor based on the Maxim 1-Wire Digital Thermometer.
Souvenir Badge for Biohacking festivals?
Similar to our SGMK 10 years badge...
http://wiki.sgmk-ssam.ch/wiki/Shenzhen_Ready
Etymology of gären
and if you wanna learn some German, check this: