Difference between revisions of "SATW-DIY Kit"
From Hackteria Wiki
(Created page with "'''Bio''' * cuvettes * eppendorf tubes * pipettes * Enymes * kitchen board * Härdöpfel... '''Elektro''' * Eletronics Starter Kit * UV-LED 5mm * UV-LED 3mm * light-dependent...") |
(→Bill of Materials) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | -> Go back to [[SATW-DIY]] | ||
| + | |||
| + | |||
| + | == Bill of Materials == | ||
| + | |||
| + | |||
'''Bio''' | '''Bio''' | ||
* cuvettes | * cuvettes | ||
| Line 16: | Line 22: | ||
* 6x Push button small | * 6x Push button small | ||
* 2x 7-Segment LEd Display | * 2x 7-Segment LEd Display | ||
| − | * | + | * Buzzer |
* Potentimeter (Variable Resistor) | * Potentimeter (Variable Resistor) | ||
* Resistors 10k Ohm | * Resistors 10k Ohm | ||
| Line 24: | Line 30: | ||
* Breadboard Fullsize | * Breadboard Fullsize | ||
* | * | ||
| + | |||
| + | '''additional''' | ||
| + | |||
| + | * blue tack | ||
| + | * piezo speakers | ||
| + | |||
| + | == Where to get it == | ||
| + | |||
| + | |||
| + | == Turbidity Meters == | ||
| + | |||
| + | |||
| + | [[File:Kafi_schnapps_detektor_calibrations_sm.jpg|800px]] | ||
Latest revision as of 19:23, 9 October 2014
-> Go back to SATW-DIY
Bill of Materials
Bio
- cuvettes
- eppendorf tubes
- pipettes
- Enymes
- kitchen board
- Härdöpfel...
Elektro
- Eletronics Starter Kit
- UV-LED 5mm
- UV-LED 3mm
- light-dependent resistor (LDR)
- Infrared-Sensor
- 2x Push button big
- 6x Push button small
- 2x 7-Segment LEd Display
- Buzzer
- Potentimeter (Variable Resistor)
- Resistors 10k Ohm
- Resistors 1k Ohm
- USB Cable mini
- Adafruit Trinket - 5.0V
- Breadboard Fullsize
additional
- blue tack
- piezo speakers
Where to get it
Turbidity Meters
