Difference between revisions of "Reflow 0603 SMT components at Home"
From Hackteria Wiki
(→Reflowing on small Hotplate) |
|||
Line 18: | Line 18: | ||
<gallery mode="packed-hover" heights=200px> | <gallery mode="packed-hover" heights=200px> | ||
− | File:reflow_05_controlPaste.jpg | + | File:reflow_05_controlPaste.jpg|Check how nicely the paste was applied. if bad, just clean it and try again |
− | File:reflow_06_placeParts.jpg | + | File:reflow_06_placeParts.jpg|Now start placing the parts with a fine tweezer |
− | File:reflow_07_readyForReflow.jpg | + | File:reflow_07_readyForReflow.jpg|Don't worry too much if they are not perfeclty positioned... it will work miraculously! |
− | File:reflow_on_hotPlate.jpg | + | File:reflow_on_hotPlate.jpg|Put it on the hotplate and start heating |
− | File:reflow_on_hotPlate_2.jpg | + | File:reflow_on_hotPlate_2.jpg|Watch the process self-aligning and soldering all the parts |
− | File:reflow_09_done.jpg | + | File:reflow_09_done.jpg|There you go, DONE! |
</gallery> | </gallery> |