Difference between revisions of "Reflow 0603 SMT components at Home"
From Hackteria Wiki
(→Reflowing on small Hotplate) |
|||
| Line 18: | Line 18: | ||
<gallery mode="packed-hover" heights=200px> | <gallery mode="packed-hover" heights=200px> | ||
| − | File:reflow_05_controlPaste.jpg | + | File:reflow_05_controlPaste.jpg|Check how nicely the paste was applied. if bad, just clean it and try again |
| − | File:reflow_06_placeParts.jpg | + | File:reflow_06_placeParts.jpg|Now start placing the parts with a fine tweezer |
| − | File:reflow_07_readyForReflow.jpg | + | File:reflow_07_readyForReflow.jpg|Don't worry too much if they are not perfeclty positioned... it will work miraculously! |
| − | File:reflow_on_hotPlate.jpg | + | File:reflow_on_hotPlate.jpg|Put it on the hotplate and start heating |
| − | File:reflow_on_hotPlate_2.jpg | + | File:reflow_on_hotPlate_2.jpg|Watch the process self-aligning and soldering all the parts |
| − | File:reflow_09_done.jpg | + | File:reflow_09_done.jpg|There you go, DONE! |
</gallery> | </gallery> | ||
Revision as of 13:34, 6 November 2022
Making the stencil
Preparing for reflow
Preparing a simple setup. Just tape things down and fix the PCB
Precisely position the stencil and tape it down in place
Add some solder paste, Mechanik seems to be the brand of choice
Use a some kinda rakel and smear it onto the pads
Reflowing on small Hotplate
Check how nicely the paste was applied. if bad, just clean it and try again
Now start placing the parts with a fine tweezer
Don't worry too much if they are not perfeclty positioned... it will work miraculously!
Put it on the hotplate and start heating
Watch the process self-aligning and soldering all the parts
There you go, DONE!
