Difference between revisions of "CO2 Soil Respiration Chamber"
From Hackteria Wiki
Line 2: | Line 2: | ||
[[File:First_CO2_setup_MH-Z19.jpg|400px]][[File:First_CO2_soil_trial_MH-Z19.jpg|400px]] | [[File:First_CO2_setup_MH-Z19.jpg|400px]][[File:First_CO2_soil_trial_MH-Z19.jpg|400px]] | ||
− | |||
− | |||
− | |||
− | |||
==More about CO2 sensors:== | ==More about CO2 sensors:== | ||
Line 16: | Line 12: | ||
==== MH-Z19: ==== | ==== MH-Z19: ==== | ||
+ | |||
+ | [[File:MH-Z19_working.jpg|400px]] | ||
+ | |||
This page is about the MH-Z19 CO2 sensor and some experiments done with it: | This page is about the MH-Z19 CO2 sensor and some experiments done with it: | ||
* https://revspace.nl/MHZ19 | * https://revspace.nl/MHZ19 |
Revision as of 12:55, 14 April 2018
Contents
CO2 soil chambers
More about CO2 sensors:
Nondispersive infrared sensor
MH-Z16:
MH-Z19:
This page is about the MH-Z19 CO2 sensor and some experiments done with it:
Using the MH-Z19 CO2 sensor PWM readout, simple arduino code:
More on ABC, Automatic Baseline Correction
Immerhin kann man den Sensor per Hd-Pin (7s gegen GND) auf 400ppm (Außenluft) eichen.
CCS811
CCS BME combo
This one I ordered 2.... but check I2C adress. and connect "WAK" to GND
- #define CCS811_ADDR 0x5A //Alternate I2C Address
- myBME280.settings.I2CAddress = 0x76;
https://www.tindie.com/products/onehorse/air-quality-sensors/