Difference between revisions of "Group 4 - MAKE - Philip"
From Hackteria Wiki
(Created page with "=DIY Chip= ==You will need== ===Material=== 1. circuit board 2. semiconductor 3. ceramic caacitor 4. insulated wire 5. piezo speaker 6. led light 7. battery 3V/9V and b...") |
(→DIY Chip) |
||
| Line 21: | Line 21: | ||
1. UV lamp | 1. UV lamp | ||
| − | 2. NaOH = developer, NaSO4 = caustic | + | 2. NaOH = developer, NaSO4 = caustic |
3. abrasive paper | 3. abrasive paper | ||
| Line 30: | Line 30: | ||
6. tweezers | 6. tweezers | ||
| + | |||
| + | ==Create a printed circuit board== | ||
| + | |||
| + | |||
| + | ==Connect components with the chip== | ||
| + | |||
| + | Step 1: Take the abrasive paper and sand the chip. | ||
| + | Step 2: Bend and shorten the edges of the semiconductor | ||
| + | Step 3: Connect the semiconductor onto the chip - !watch the direction of the semiconductor! | ||
| + | Step 4: Add the other components (ceramic capacitor, led light, speaker, battery connection) | ||
| + | Step 5: Connect the battery and make noise :D | ||
| + | |||
| + | Tipp: for a louder output use a 9V battery or connect the chip to an external speaker. | ||
Revision as of 14:37, 6 May 2015
Contents
DIY Chip
You will need
Material
1. circuit board
2. semiconductor
3. ceramic caacitor
4. insulated wire
5. piezo speaker
6. led light
7. battery 3V/9V and battery connection
Tools
1. UV lamp
2. NaOH = developer, NaSO4 = caustic
3. abrasive paper
4. soldering bolt, solder
5. wire cutter
6. tweezers
Create a printed circuit board
Connect components with the chip
Step 1: Take the abrasive paper and sand the chip. Step 2: Bend and shorten the edges of the semiconductor Step 3: Connect the semiconductor onto the chip - !watch the direction of the semiconductor! Step 4: Add the other components (ceramic capacitor, led light, speaker, battery connection) Step 5: Connect the battery and make noise :D
Tipp: for a louder output use a 9V battery or connect the chip to an external speaker.
