Difference between revisions of "DIY Microfluidics"
|Line 76:||Line 76:|
Latest revision as of 09:57, 17 September 2019
Stuff from wetPONG, DIY Microfluidics Class, FHNW, 2008-2012
See instructions on the wetPONG website HomeMade Microfluidics on wetPONG
more coming soon... or check some of our tools on this fbook post.
Advanced DIY Microfluidics
Preparing the slide
Draw a nice pattern with InkScape
Putting (black) tape on a glas slide. Cut it with a sharp knife or with a DIY laser cutter 8-)
DIY laser cutter:
The slide with the cut tape
Peel of the tape carefully
Some sample slides
Putting the slides in casting boxes
Cast with PDMS and cure at 60°C for about 1 hour.
Remove the cast
Plasma activate a clean glas slide and the PDMS piece (where to get the plasma from?)
Put the PDMS piece back into a clean box and cover with a tube holder plate. Punch the holes.
Attatch tubes and capture the microflow with a webcam stage.
Parts lasercut from acrylic in the FabLab Lucern.
File with drawings of the cast forms and webcam stage: File:UFlow Casts.pdf